INSTRUCTIONS FOR HT-338, HT-218, and LY-600A:
-
First thread the tail into the head of the cable tie.
-
Adjust the wheel to the required tension for the cable tie.
-
Place the tail and shaft of the cable tie into the solt at the tip of the gun barrel.
-
Push the tie as far back onto the gun base as possible.
The head must be touching the gun tip outside the tool. -
Squeeze the handle of the gun to pull the tie through the head making sure the head of the tie is always touching the tip of the gun.
-
Keep pulling the handle until the tie is securely fastened around the desired object.
-
The gun will automatically cut the excess tie off when it reaches maximum tension.
INSTRUCTIONS FOR LY-600L
-
First thread the tail into the head of the cable tie.
-
Adjust the wheel at the back of the tool to the required tension.
-
Place the tail and shaft of the cable tie into the solt with the lip and through the slot at the back. The head must be touching/ resting upon the tool.
-
Squeeze the handle of the tool to pull the tie through the head making sure the head of the tie is always touching the outside of the tool.
-
Keep pulling the handle until the tie is securely fastened around the desired object.
-
The gun will automatically cut the excess tie off when it reaches maximum tension.